ResMed Quattro Air NV User Manual page 18

Therapy
pressure
Resistance
Environmental
conditions
Gross
dimensions
Mask fully
assembled with
elbow assembly
(no headgear)
Service life
Notes:
•
The mask system does not contain PVC, DEHP or phthalates.
•
This product is not made with natural rubber latex.
•
The manufacturer reserves the right to change these specifications
without notice.
Storage
Ensure that the mask is thoroughly clean and dry before storing it for any
length of time. Store the mask in a dry place out of direct sunlight.
Disposal
This mask and packaging do not contain any hazardous substances and
may be disposed of with your normal household refuse.
0 to 40 cm H O
2
Drop in pressure measured (nominal)
at 50 L/min: 0.1 cm H
at 100 L/min: 0.5 cm H
Operating temperature: +5°C to +40°C
Operating humidity: 15% to 95% non-condensing
Storage and transport temperature: -20°C to +60°C
Storage and transport humidity: up to 95% non-condensing
Extra Small:
156 mm (H) x 103 mm (W) x 111 mm (D)
Small:
156 mm (H) x 103 mm (W) x 112 mm (D)
Medium:
175 mm (H) x 103 mm (W) x 112 mm (D)
Large:
175 mm (H) x 103 mm (W) x 112 mm (D)
The service life of the mask system is dependent on the intensity of
usage, maintenance, and environmental conditions to which the mask
is used or stored. As this mask system and its components are
modular in nature, it is recommended that the user maintain and
inspect it on a regular basis, and replace the mask system or any
components if deemed necessary or according to the instructions in
the 'Cleaning your mask' section of this guide.
O
2
O
2
English 7