ResMed Quattro Air NV User Manual page 15

Removing your mask using the quick release cord
1. Pull the quick release cord down. The quick release clip separates
from the mask.
2. Pull the mask away from your face and back over your head.
Disassembly
1. Unhook the upper headgear straps from the frame. There is no need
to undo the fastening tabs.
2. Remove the elbow from the mask by pressing the side buttons and
pulling the elbow away. Remove the elbow from the air tubing.
3. While holding the bottom of the hook, pull the corner of the frame
slightly away from the side of the mask.
4. Remove the frame from the rest of the mask.
Reassembly
1. Press the frame onto the rest of the mask, ensuring it clicks into place
at the top and at both bottom corners.
2. Attach the top headgear straps to the frame by looping through each
of the upper headgear hooks. Ensure that the ResMed logo on the
headgear is facing outward and right side up.
3. If the quick release clip has been removed from the frame, reattach it
by threading it onto the lower right headgear hook.
4. If the quick release has been disassembled, reclip the parts together
as shown in the reassembly illustrations.
5. If the quick release has been removed from the headgear, thread the
lower right headgear strap through the slot on the quick release. Fold
the tab over to reattach.
6. Attach the elbow to the air tubing. Attach the elbow and air tubing to
the mask by pressing the side buttons and pushing the elbow into the
mask. Pull on the elbow to check that it sits securely in the mask.
Cleaning your mask in your home
Your mask and headgear should only be handwashed by gently rubbing in
warm (approximately 30°C) water using mild soap. All components should
be rinsed well with drinking quality water and allowed to air dry out of
direct sunlight.
4