Table of Contents
Advertisement
Figure 1: OUTDOOR - MINIMUM CLEARANCES (Indoor Clearances Page 10)
NOTE: ANGLE MOUNT IS MAXIMUM 30° TO AVOID DAMAGE
Table 1: OUTDOOR - MINIMUM CLEARANCES TO COMBUSTIBLES
Application
OUTDOOR RSEP1S25X - NG/LPG
OUTDOOR RSEP1S35X - NG/LPG
OUTDOOR RSEP2S50N - NG Only
See Table 2 Next Page for "Suggested Mounting Height for Comfort"
Note: Do not mount less than 8 ft [2438 mm] above floor.
Do not store or place anything directly under heater
Ensure mounting height in any location is sufficient to prevent patrons from
coming in contact with heater, and clearance to combustibles is maintained.
The clearance to combustible material represents the minimum distance that must be main-
tained between the outer heater surface and a nearby surface. In an OUTDOOR application
the stated clearance to combustibles represents a surface temperature of 90F° (50C°) above
ambient temperature.
It is the installer's responsibility to ensure that building materials with a low heat tolerance
which may degrade at lower temperatures are protected to prevent degradation. Examples of
low heat tolerance materials include awnings, vinyl siding, fabrics, some plastics, filmy materi-
als, etc.
MODEL NO
Horizontal
30° Angle
A
S
T
5.5"
7"
9.5"
7.5"
9"
9.5"
12"
28"
16"
7
SE+ Series Infrared Gas Heater Installation and Operation Manual
Under Ends
B
F
U
1"
9.5"
48"
1.5"
21"
48"
10"
36"
60"
E
3"
5"
21"
Advertisement
Table of Contents
