Miller Electric Millermatic 350P Aluminum Owner's Manual page 31

5-14. Connecting 1-Phase Input Power (Continued)
!
Installation must meet all National and
Local Codes - have only qualified
persons make this installation.
!
Disconnect and lockout/tagout input
power before connecting input con-
ductors from unit. Follow established
procedures regarding the installation
and removal of lockout/tagout
devices.
!
Always connect green or green/yellow
conductor to supply grounding terminal
first, and never to a line terminal.
See rating label on unit and check input volt-
age available at site.
Notes
.
A complete Parts List is available at www.MillerWelds.com
1 Input Power Cord Strain Relief
2 Black And White Input Conductor (L1
And L2)
3 Red Input Conductor
4 Green Or Green/Yellow Grounding
Conductor
5 Insulation Sleeving
6 Electrical Tape
Insulate and isolate red conductor as shown.
7 Input Power Cord.
8 Disconnect Device (switch shown in
the OFF position)
9 Disconnect Device Grounding Terminal
10 Disconnect Device Line Terminals
Connect green or green/yellow grounding
conductor to disconnect device grounding
terminal first.
Connect input conductors L1 and L2 to dis-
connect device line terminals.
11 Over-Current Protection
Select type and size of over-current protec-
tion using Section 5-11 (fused disconnect
switch shown).
Close and secure door on disconnect device.
Follow established lockout/tagout proced-
ures to put unit in service.
Work like a Pro!
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.
OM-254915 Page 27
input1 2012−05