Remote Retrieval; Using Your Remote Access Code; Remote Commands; Change Fax Forwarding Setting - Brother MFC-925 Owner's Manual

R E M O T E F A X O P T I O N S ( F A X - 9 2 0 A N D M F C - 9 2 5 )

Remote Retrieval

You can call your machine from any touch tone phone (or remote Group
3 fax machine) and use a Remote Access Code and other button presses
to retrieve fax messages.

Using Your Remote Access Code

1
2
3
4
5
6
If your fax machine is set to MANUAL mode, you can access your
machine remotely by phoning it and letting it ring for about 100 seconds.
Your fax machine will answer the phone after 100 seconds of ringing,
and you then have 30 seconds to enter your Remote Access Code.

Remote Commands

Follow the commands below to access features remotely. When you call
the fax machine and enter your Remote Access Code (159 ), the system
will signal you with two short beeps to enter a remote control command.

Change Fax Forwarding Setting

Press 9 5
then to
Turn Fax Forwarding OFF––Press 1.
Turn Fax Forwarding ON––Press 2.
Program Fax Forward Number––Press 4. Automatically, the machine
Dial your fax machine phone number from a touch tone phone.
When your fax machine answers and beeps, immediately enter your
Remote Access Code (159 ).
The fax machine signals the kinds of messages received:
1 long beep––Fax message(s)
No long beep––no messages
The fax machine then prompts you with two short beeps to enter a
command. If you wait longer than 30 seconds to enter a command,
the machine hangs up. If you enter an invalid command, the machine
beeps three times.
Press 9 0 to reset the machine when you finish.
Hang up.
will turn Fax Forwarding ON.
85