Precautions For Safe Use - Leica DVM5000 Setup Manual

Precautions for Safe Use

Power Supply and Cables
Connect the power supply plug directly into the 3-pole socket with
z
ground terminal, 100 to 240 VAC, 50/ 60 Hz, and 15 A min. Using a
power strip to extend or share the power supply may cause fire or
electric shock.
If the product is not going to be used for long periods of time, the
z
power cable plug must be disconnected from the power outlet.
Do not touch the power plug with wet hands. Doing so may result in
z
electric shock.
Do not place the power cable near heaters etc. or damage it.
z
If thunder is heard, do not touch the power plug.
z
Before connecting/disconnecting the cables, make sure that the
z
power to is turned OFF. Failure to observe this may result in fire or
electric shock.
Before moving the product to another site, the power cable and
z
connecting cables must be removed. Damage to the cables may result
in fire or electric shock.
The power cable included in the package is designed to be used in
z
Japan only. When it is used in a foreign country, please contact your
Leica Microsystems representative for information regarding the
approved power cable for use in that country according to the selec-
tion table ( P40).
Leica DVM-series
Laser Safety
The Leica DVM5000 uses laser. Class 1 Laser Product
This product conforms to the requirements of DHHS rules 21 CFR Subchap-
ter J for Class 1 Laser Products. It also conforms to the requirements of (IEC
60825-1/A1: 2002) for Class 1 Laser Products.
Regulations and Standards
The equipment conforms with the following standards:
EN 61326
EN 61010-1
Following the provisions of directives:
Electromagnetic compatibility - 2004/108/EG
Electrical equipment designed for use within certain voltage limits -
2006/95/EG
Setup Manual 6