LG WT7800C Series Service Manual page 27

③ Remove the screws that secure the water guide.
④ Disconnect stator connection before removing the
stator in the subsequent step.
⑤ Remove the Three screws securing the Stator.
⑥ Check the position of the snap ring, being cure it
faces the rotor and stator.
⑦ To keep from dropping the stator, loosen the Three
bolts almost all the way; then hold the stator in one
hand while removing the bolts with the other.
⑧ Be careful during removal and replacement to avoid
cutting, nicking, or pinching any of the wires. This could
cause a short or electrical noise in the machine.
Must assemble the 2T washer before
Caution
assemble the rotor. If not, there will be
damage to driving parts.
When assembling the rotor, hold the outer
parts and to axial direction.
Be careful your fingers are not stuck
between rotor and stator by magnetic force.
27
Copyright © 2016 - 2017 LG Electronics Inc. All rights
reserved. Only training and service purposes.