Installation alternative A.
Drive and engine as one unit
1
Install the S-drive to the engine.
Lift the engine and the drive onto the boat.
WARNING! Always use both lifting eyes when
lifting the engine.
2
Put the clamp ring on top of the diaphragm.
Install the engine and S-drive.
3
20 Nm
(15 lb.ft)
Tighten the clamp ring to the bed.
NOTE! Use no chemicals like grease, silicon etc. on
the diaphragm.
Tighten the rear mount to the clamp ring.
NOTE! D2-55, D2-75 only: Mount distance plate (A).
4
70 Nm
(52 lb.ft)
D2-55
D2-75
Install the front mounts.
NOTE! D2-55 and D2-75 has two washers between
mount and engine bracket.
S - drive installation
A
40 Nm
(30 lb.ft)
20 Nm
(15 lb.ft)
A
40 Nm
(30 lb.ft)
47