S-drive installation
Cutting and fiberglassing of
engine bed, step 9–23
9
Put the bed in its position and align it so it is hor-
isontal.
10
Make a marking on the bed according to figure
above.
NOTE! Recommended distance: 40 mm (1.6").
11
Adjust a pair of compasses to the distance be-
tween the hull and the marking made at fig. 10.
Make a line around the complete bed at this height.
44
12
Cut the bed according to this line.
13
Min. 40 mm
(1.6")
Grind off the gelcoat on the surface of the bed
where there will be covered with fibre glass.
14
Put the bed back in the hull, position it correctly
and make a marking around it.