Rubber mounts
D1-20 and D1-30, Inboard
A- measurement, D1 and D2
Unloaded conditions
Transmission
Front
mm (")
Reverse gear
85±8 (3.3±0.3)
S-drive
Fixed
NOTE! Make sure that the rubber mounts are in-
stalled so that no pre-load or side forces occur when
the engine has been installed and aligned with the
propeller shaft.
Compare front and rear mounts sidewise in pairs.
Adjust if necessary.
A
A
Tightening torque
Tightening torque, rubber mounts,
all D1 and D2 engines: 70 Nm (52 lb.ft)
A
Rear
mm (")
85±8 (3.3±0.3)
Fixed
70 Nm (52 lb.ft)
70Nm (52 lb.ft)
Engine Instillation
13