Fuel system
Piping
All fuel lines should be installed and properly
clamped near the bottom of the boat to avoid heat
absorption. The air temperature is lower at the bot-
tom of the engine room.
Rubber hoses
Clamp the fuel line. Distance between clamps ap-
prox. 300 mm (12").
Make sure the hose cannot be damaged by sharp
edges.
NOTE! Legal requirements may demand fuel shut-off
valve on return line.
Inner diameter
Required minimum inner diameter for
feed line hose: 10 mm (3/8").
return hose: 10 mm (3/8").
NOTE! Only use approved flexible hose.
Inner diameter
10 mm (3/8")
Connections
Min. inner diameter: 7.0 mm (0.28")
Male thread : 1/4" NPTF
Volvo Penta part no.: 3825000
Engine Instillation
31