DeWalt XGST227CS Operator's Manual page 15

INSTALLING THE CUTTING HEAD SHIELD
(DXGST227SS)
WARNING:
cutting head shield in place.
1. Remove the wing nut and washer from the cutting head shield.
2. Insert the short tab (the one without a hole) on the mount bracket into the slot on the cutting head
shield (Fig. 3).
3. Rotate the cutting head shield until the bolt on the cutting head shield protrudes through the hole
on the mount bracket (Fig. 3).
4. Place the washer onto the bolt (Fig. 4).
5. Screw the wing nut onto the bolt until the cutting head shield is firmly in place (Fig. 4).
Cutting Head Shield
To prevent serious personal injury, never operate the unit without the
Hole
Bolt
Bolt
Fig. 3
Fig. 4
15
Mount Bracket
Tab
Slot
Wing Nut
Washer