Troubleshooting - DeWalt XGST227CS Operator's Manual

Long-term Storage
1. Remove the fuel cap, tip the unit and drain the fuel into an approved container. Reinstall the fuel cap.
2. Start the engine and allow it to run until it stalls. This ensures that all fuel has been drained from
the carburetor.
3. Allow the engine to cool. Remove the spark plug and put 5 drops of any high-quality motor oil or
2-cycle oil into the cylinder. Pull the starter rope slowly to distribute the oil. Reinstall the spark plug.
4. Thoroughly clean the unit and inspect it for any loose or damaged parts. Repair or replace
damaged parts and tighten loose screws, nuts or bolts.
Preparing the Unit for Use after Long-term Storage
1. Remove the spark plug. Tip the unit and drain all of the oil from the cylinder into an approved
container. Reinstall the spark plug.
NOTE: Do not use fuel that has been stored for more than 30 days. Dispose of old fuel and oil
according to federal, state and local regulations.
PROBLEM
THE ENGINE WILL NOT START
The fuel tank is empty
The primer bulb was not pressed enough
The engine is flooded
The fuel is old (over 30 days) and/or improperly
mixed
The spark plug is fouled
THE ENGINE WILL NOT IDLE
The air filter is dirty
The fuel is old (over 30 days) and/or improperly
mixed
The idle speed is incorrect

TROUBLESHOOTING

SOLUTION
Fill the fuel tank with properly-mixed fuel
Press the primer bulb 10 times
Move the choke lever to Position B, press the
throttle lockout, squeeze the throttle control and
pull the starter rope until the engine starts
Drain the fuel tank and add fresh, properly-
mixed fuel
Replace the spark plug
Clean or replace the air filter
Drain the fuel tank and add fresh, properly-
mixed fuel
Adjust the idle speed
35