Preparing For Use; Safety-Related Aspects To Consider When Configuring The Plant; Observing The Operating Mode; Machines Without Final Paint Coating - Siemens SIMOTICS SD 1LE5 Operating Instructions Manual

Preparing for use

Good planning and preparation of machine applications are essential in terms of keeping
installation simple and avoiding errors, ensuring safe operation, and allowing access to the
machine for servicing and corrective maintenance.
This chapter outlines what you need to consider when engineering/configuring your plant in
relation to this machine and the preparations you need to make before the machine is
delivered.
4.1

Safety-related aspects to consider when configuring the plant

A number of residual risks are associated with the machine. These are described in the
chapter titled "Safety information" (Page 11) and in related sections.
Take appropriate safety precautions (covers, barriers, markings, etc.) to ensure the machine is
operated safely within your plant.
4.2

Observing the operating mode

Observe the machine's operating mode. Use a suitable control system to prevent overspeeds,
thus protecting the machine from damage.
4.3

Machines without final paint coating

For machines, which are only delivered with primer, you must paint them to comply with the
applicable guidelines for the specific application. The primer alone does not provide adequate
corrosion protection.
Please contact the Service Center for recommendations relating to the paint finish.
1LE5, 1PC4 shaft height 315/355
Operating Instructions, 10/2020, A5E41454666A
4
27