Installer Checklist; Final Instructions; Self Help Hints - Blomberg DWT 14210NBL00 Installation Manual

Ý Notice :
The installer is responsible for the dishwasher
installation. Incorrect installation is not covered by
the warranty.

8. INSTALLER CHECKLIST

Your installer must have completed and checked
the following:
The dishwasher is square and level.
=
The dishwasher is fastened securely to the
=
cabinetry.
The dishwasher door opens and closes freely.
=
The dishwasher door must close without hitting
any cabinetry or counter top.
The inlet water supply is turned on and checked
=
for leaks.
The drain hose has been connected and checked
=
for leaks. There must be no kinks or obstructions
in the drain hose.
The drain hose must be installed with a 28" (710
=
mm) high drain loop for drain hook-ups without
any air removed.
If the dishwasher drain is hooked up to a garbage
=
disposal, the drain hopper plug must be removed.
The spray arms are free and rotate freely.
=
The rinse cycle has been run.
=
The water level will be below the filter screen
=
after the end of the wash program. It is normal
to find some water in the drain filter area.
Set the water softener to the correct water
=
hardness for your area. If the dishwasher drain
is connected to a garbage disposal, make sure
that the drain/hopper plug has been removed.

9. FINAL INSTRUCTIONS

1. Press the On/Off button to turn the dishwasher
on.
2. Power indicator light comes on.
3. Use the Cycle Select button to choose a washing
program.
4. Start the program with the Start/Pause button.
5. Run the dishwasher through one complete cycle.
When the progress indicator light “End” lights
up, the wash cycle is completed. Use the On/Off
button to turn the dishwasher off.
Ý Notice :
If the dishwasher does not operate properly, refer to the

self help hints.

10. SELF HELP HINTS:
The power indicator light doesn’t come on:
Check to make sure the breaker to the dishwasher
=
is in the on position.
Check all the wire connections in the junction box
=
are tight and not loose.
No Water is coming into the dishwasher:
Check to make sure the hot water shut-off is in the
=
ON position.
Water does not drain:
Make sure drain hose is not kinked or comes out of
=
air gap next to the sink.
Remove drain hose from disposal making sure plug
=
is removed.
Ý
Notice :
If your dishwasher is not operating properly after
=
following these steps: Contact your dealer to
schedule an authorized service agent to inspect
your new dishwasher for any function related failure.
The manufacturer warranty does not cover
=
installation or customer education service visits.
DWT xxxxx xxxxx
You will find the model and serial number information
on the label located on the right-hand side of the inner
door of your dishwasher, as shown above.
Ý
Notice :
Please make a copy of your invoice and keep it with this
manual and register your dishwasher on-line.
23
Installation Manual-USA