Supply Voltages; Loudspeakers - Grundig WKC 5201 RDS Operating Instructions Manual

Supply voltages

+
Blade contacts A: Figure
A8 – operating voltage (earth)
Connect to terminal 31 (earth) of the vehicle.
A7 +12 V operating voltage
Connect to terminal 30 (permanent plus) of
the vehicle.
A6 Instrument illumination
Connect the blade contact A6 to terminal 58
of the vehicle:
When the vehicle's headlights are switched on
and the car radio is switched off, the illumina-
tion of of the car radio controls can be set
with the instrument illumination control.
Blade contact A6 not connected:
no radio illumination when the radio is
switched off.
A5 +12 V switching voltage output
(max. 0.5 A)
on bladec contact A 5 when the radio is
switched on.
For automatic aerial (extend/retract),
aerial amplifier (operating voltage) etc.
A4 +12 V ignition voltage
Connect to terminal 15 or terminal 30 of the
vehicle:
– Terminal 15, if you wish to switch the car
radio on and off with the ignition/start
switch.
– Terminal 30, if you do not wish to switch
the car radio on and off with the
ignition/start switch.
A2 Phone connector (Mute)
for car telephone or CB radio:
The car radio is "muted" when the car tele-
phone or CB radio is in operation.
The display indicates "MUTE"
For this, the blade contact A2 must be
connected from the mute output of the tele-
phone/CB radio to earth!
A1 SCV connection (+)
for "speed-controlled Volume".
24
Installation and Removal

Loudspeakers

+
Blade contacts B: Figure
Maximum output power
with 4 Ω loudspeakers: 4 x 20 W
í
Do not electrically connect speaker
connections to each other and do not
connect to chassis!
Front speakers Rear speakers
B3 right-hand + B1 right-hand +
B4 right-hand – B2 right-hand –
B5 left-hand + B7 left-hand +
B6 left-hand – B8 left-hand –