Stihl SR 5600 Instruction Manual page 6

English
Plant control chemicals may be used
only by persons trained in their handling
and the appropriate first-aid measures.
Keep instructions or label of the plant
control chemical available at all times in
order to inform the doctor about the
chemical concerned in an emergency. In
an emergency, follow the chemical
manufacturer's instructions provided or
on the label.
Mixing the spray solution
Mix the plant protection product strictly
in accordance with the manufacturer's
instructions – incorrect mixtures may
produce toxic fumes or explosive
solutions.
Never spray liquid plant control
–
chemicals undiluted.
Prepare solution and fill the
–
container outdoors only or in well-
ventilated locations.
Only prepare sufficient solution for
–
the job in hand so that nothing is left
over.
Mix different chemicals only in
–
accordance with the manufacturer's
instructions – incorrect mixtures
may produce toxic fumes or
explosive solutions.
Do not mix different plant protection
–
products unless such a mixture is
approved by the manufacturer.
4
Filling the Solution Container
Stand the sprayer on a level surface
–
– do not fill the solution container
above the maximum mark.
To reduce the risk of injury, do not
–
fill the unit while wearing it on your
back.
Close the valve lever before filling.
–
When filling from central water
–
supply, do not immerse the end of
the hose in the solution – sudden
low pressure in the system may
cause the solution to be sucked
back into the water supply.
Before filling the container with
–
spray solution, carry out test run
with fresh water and check all parts
of the sprayer for leaks.
After filling, fit the filler cap and
–
tighten it down firmly.
Application
Work only in the open or in very well
–
ventilated locations, e.g. open
greenhouses.
Do not eat, drink or smoke while
–
working with plant control
chemicals.
Never blow through nozzles or other
–
components by mouth.
Avoid contact with plant control
–
chemicals – immediately change
clothing contaminated with plant
control chemical.
Do not spray in windy conditions.
–
Unfavorable weather conditions may
result in an incorrect concentration of the
plant protection product. Overdosing
may damage plants and the
environment. Under-dosing may result
in unsuccessful plant treatment.
In order to reduce the risk of damage to
the environment and plants, do not
operate the sprayer:
in windy conditions
–
at temperatures above 25°C in the
–
shade
in direct sunlight
–
In order to reduce the risk of accidents
and damage to the sprayer, never
operate the sprayer with:
flammable liquids
–
viscous or sticky liquids
–
caustic or corrosive chemicals
–
liquids hotter than 50°C
–
Storage
During work breaks, do not leave
–
the unit in the hot sun or near any
heat source.
Do not store spray solution in the
–
sprayer for longer than one day.
Store and transport spray solution
–
only in approved containers.
Never store the spray solution in
–
containers intended for foods,
drinks or animal feed.
Do not store spray solution with
–
foods, drinks or animal feed.
Keep spray solution out of the reach
–
of children and animals.
Store the power tool empty and
–
clean.
SR 5600