Table of Contents
Advertisement
SPECIFICATIONS
A
Model
953086.000
Min./Max.
A = Length
88-1/2"
B = Front (Height)
C = Rear (Height)
79-1/2"/86-1/2" 86-1/2"/96-1/2"
D = (Width)
86"/91"
E = Ramp Stand
*Range
16"/28"
Capacity
1,200 lbs.
* Ramp stand adjusts with one inch increments.
C
B
D
E
953091.000
Min./Max.
91-1/2"
75"
75"
91"/99"
16"/28"
1,200 lbs.
TM
X-TEND A-ROOM
INSTALLATION AND OPERATING INSTRUCTIONS
GENERAL INSTRUCTIONS
These instructions must be read and under-
stood before installation of this kit. Modifica-
tion of this product can be extremely hazard-
ous and could result in personal injury and/
or property damage.
TM
The X Tend A-Room
loading ramp opening of a cargo type trailer, allowing users
to enjoy the extra living space.
Product features and specifications as described or illus-
trated are subject to change without notice. Installation
methods not described in this manual must have written
approval from Dometic Corporation.
Important:
Read the entire Installation and Operat-
ing Instructions carefully before starting the installa-
tion.
Contents:
(1) Instructions
(1) Roll of Hook Tape
(1) Oxford Storage Bag
(1) Ctr Roof Pole Assm.
(2) Ramp Stand
(1) Pole Storage Bag
(2) Twist Fasteners
Tools Required:
Power Drill/Screwdriver
INSTALLATION
Park the trailer on flat and level surface for the initial
installation. This will insure that the X Tend A-Room
straight and square with the trailer.
A. Ramp Stand Assembly
1. Find the channel with a threaded nylon insert . Place
the threaded nylon insert with the notch up.
2. Place the second channel with a hole across the first
channel with the hole on top forming the letter "X".
3. The stand pole with the stud bolt is screwed into the
nylon insert through the channel with the hole. This
should be tightened so there is no movement.
4. The top stand pole slides on the bottom assembly
and is locked in place with the ball pin. See Fig. 1.
Note: Each ramp stand has a rubber coating on the top plate
to prevent scratching of the ramp.
B. Ramp Preparation
1. Place ramp stands at the approximate positions for
each corner of the ramp.If terrain is not level, add
leveling blocks as necessary to even out weight and
level to ramp stands.
3
is designed to be installed around the
(1) Fabric Assm.
(4) Ball End Sockets
(4) J-Hooks
(1) Front Pole Assm.
(1) Rear Pole Assm.
(1) Center Pole Support
(8) #8 x 3/4" Screws
TM
will be
Advertisement
Table of Contents
