Dometic X-TEND A-ROOM Installation & Operating Instructions Manual page 4

FIG. 1
Top Stand
Pole
Stand Pole
Stud Bolt
Channel With
Hole
2. Pull the ball pin and raise/lower each ramp stand to
the approximate position where the ramp will be
approximately level. Align stand extension with the
closest hole in the base and replace the stand pin.
3. Lower the ramp and move the ramp stands in
position (6" to 8" from the edges) under the 2 outer
ramp corners. See Fig. 2.
FIG. 2
Place Stands At Outer Ramp Corners
C. Description Of Pole Assemblies
There are 3 pole assemblies:
Center Roof Pole Assembly
Rear/Frame Pole Assembly
Front Pole Assembly
All pole assemblies are shock corded and numbered
with stickers to identify matching assembly poles. See
Figs. 3, 4 & 5.
1. Extend all 3 pole assemblies to their longest length.
a. Center Pole Assembly
The center pole assembly is made of 3 pieces
and rest along the expansion zipper on the
center of the roof of the inside of the X Tend A-
TM
Room and parallel with the zipper. The pole
has a "C" clip on one end and a ball on opposite
end. See Fig. 3.
Ball Pin
Lower Stand
Pole
Channel With
Nylon Insert
Lower
Ramp
4
X-TEND A-ROOM TM INSTALLATION AND OPERATING INSTRUCTIONS
FIG. 3
Center Pole Assembly
3A
Ball
End
b. Front pole assembly
The front pole contains 11 pieces. When as-
sembled, the horizontal poles will form an arch
between the vertical poles. The vertical poles
have a ball end, which will be inserted into an
end ball socket on the ramp floor. See Fig. 4.
Extend the vertical telescoping poles to their
longest length. Lock in place with the lock lever.
See Fig. 4.
FIG. 4
Lock
Levers
Front Pole Assembly
c. Rear/Frame Pole Assembly
The rear/frame pole when assembled, will form
a square. The vertical poles will be capped on
the bottom end, and will be placed on the trailer
floor. See Fig. 5.
"C" Clip
3B
3C
Lock
Lever
2A
2B
2C
2D
2E
2F
Ball
End