Selecting An Am Radio Station; Automatic Seek Tuning; Manual Tuning; Scan/Seek Tuning - Blaupunkt RNS149 Operating Instructions Manual

Radio operation
Selecting an AM radio stations
In AM radio operation, you can select stations both automatically and manually.

Automatic seek tuning

To select stations automatically,
on the rocker switch 7 to start seek tuning up or
Press
on the rocker switch 7 to start seek tuning down.
The system will tune into the next available station.

Manual tuning

You can also select AM stations manually if you know their frequency. This is
useful if you would like to select a station which is not detected by automatic
seek tuning.
Press << or >> on the rocker switch 7.

Scan/seek tuning

During Scan/seek tuning, the system searches through the entire band to find
radio stations within reception range. Each station found is played for ten sec-
onds. If you do not end the Scan/seek tuning function, it will end automatically
after it has run through the entire waveband once. Please note that, if the TA
function is active, only those stations which support traffic information will be
selected (TP symbol in the display). (European systems only)

Starting Scan/seek tuning

To start Scan/seek tuning,
Press TU @ to switch to the Tuner function menu for the tuner and
Press the softkey marked SCAN .
Scan/seek tuning will begin. A symbol in the foreground of the display indicates
the progress of the Scan function.
ENGLISH FRANÇAIS
Tuner function menu
Main tuner menu, SCAN function active
ESPAÑOL
21