Entering Security Code After Power Has Been Disconnected From The Vehicle Battery - Blaupunkt RNS149 Operating Instructions Manual

General operating instructions
Entering security code after power has been disconnected
from the vehicle battery
If you attempt to switch on a coded system after it has been disconnected from
the vehicle battery, e.g. after a repair has been made to the vehicle, a code icon
will appear in the display. Enter the factory security code as follows:
Use << >> on the rocker switch 7 to mark the first digit of the code
number,
Press OK 8.
The cursor for the code input will move one position to the right.
Now select the second digit of the code number and press OK 8 to
confirm your selection.
Enter the remaining digits of the code number in the same way.
If you enter an incorrect digit by mistake,
Mark the symbol to delete the digit and
Press OK 8.
Once you have completed entering the code number,
-symbol and press OK 8 to confirm your selection.
Mark the
The system will switch on. If you enter and confirm an incorrect code number by
mistake, you can repeat your entry. To prevent thieves from discovering the
code number by trial and error, the system will be blocked for one hour after an
incorrect code is entered for the third time. The system must remain switched on
for this time to count down. If the system is disconnected from the power supply
during this waiting period, the time will be reset to one hour once again.
Please record your code number and store it in a secure place in the event of
vehicle battery failure, or disconnection service. Should you need your security
code, please call (800) 266 - 2528, option #6 M-F 9AM - 4PM CST. Please have
your warrenty number from the radio chassis or owners documentation. (Proof
of purchase required)
ENGLISH FRANÇAIS
Code Display
ESPAÑOL
15