Chapter
2
To connect the set to the OmniPCX:
1. Turn the set over
2. Plug the RJ11 cable in the corresponding set connector
3. Plug the other end of the cable onto the UA board on which the set has been declared
The set starts initializing automatically.
If this is the first set initialization or when there has been an upgrade of the OmniPCX
software version, the Alcatel 4029/4039 set downloads binary and data files.
Note: Both sets can be used prior to binary and data file download. As this download may take some
time, it can be delayed by the system administrator to start when users are not at their desk, see:
module Alcatel 9 Series Sets - Configuration procedure
The alarm, message and hands-free LEDs flash until download and initialization are over.
2-2
Figure 2.2: Alcatel 4029 Initialization Example
Figure 2.3: Initialized Alcatel 4029 Example