Toro Reelmaster 3100-D Service Manual page 297

1. Magnet support
2. Washer head bolt
3. Strike bracket
4. Washer head bolt
5. Magnet catch
6. Rivet
7. Cover bracket
8. Control panel cover
9. Lock nut
10. Parking brake spacer
11. Lever assembly
12. Flat washer
Removing the Brake Linkages
Installing the Brake Linkages
Reelmaster ® 3100-D/3105-D
20252SL Rev A
Figure 157 (continued)
13. Parking brake link
14. Clevis pin
15. Cotter pin
16. Clevis pin
17. Cotter pin
18. Lock nut
19. Flat washer
20. Switch
21. Slotted hex head screw
22. Bolt
23. Nut
24. Brake pivot shaft
1. Park machine on a level surface, lower cutting units, stop engine, engage
parking brake, and remove key from the key switch.
2. Remove the control panel cover from the machine.
When removing the adjustable clevis from either the brake pivot
shaft or adjustment rod or the brake lever from the cam shaft on the
brake assembly, make sure to match mark both parts. Marking both
parts will make reassembly and brake adjustment easier.
3. Remove the parts as necessary to repair brake linkages using
as a guide.
1. Install the removed parts onto the brake linkages using
2. Install the control panel cover to the machine.
Always check and adjust the brakes anytime brake linkages are
disassembled or repaired.
3. Adjust the brake linkages (refer to
25.
26.
27.
28.
29.
30.
31.
32.
33.
34.
IMPORTANT
IMPORTANT
Adjusting the Brake (page
Page 7–19 Wheels, Brakes and Chassis: Service and Repairs
Flange bushing
Brake pivot bracket
Cotter pin
Clevis pin
Jam nut
Cotter pin
Brake lever
Retaining ring
Adjustment rod
Adjustable clevis
Figure 157
Figure 157 as a guide.
7–3)).