Table of Contents
Advertisement
Trees from different areas will vary in mineral content. That
is why some fuels produce more clinkers than others.
Moisture
Always burn dry fuel. Burning fuel with high moisture
content takes heat from the fuel and tends to cool the
appliance, robbing heat from your home. Damp pellet fuel
can clog the feed system.
Size
•
Pellets are either 1/4 inch or 5/16 inch (6-8mm) in
diameter
•
Length should be no more that 1-1/2 inches (38mm)
•
Pellet lengths can vary from lot to lot from the same
manufacturer
•
Due to length variations, the feed rate may need
adjusting occasionally
Performance
•
Higher ash content requires the fire pot and the ash
drawer to be emptied more frequently
•
Hardwoods require more air to burn properly
•
Premium wood pellets produce the highest heat output
•
Burning pellets longer than 1-1/2 inches (38mm) can
cause an inconsistent fuel feed rate and/or missed
ignitions or feed jams.
Changing to Different Fuel Type
•
Empty the hopper of the previous fuel
•
Thoroughly vacuum hopper before filling with the
new fuel
CAUTION
Tested and approved for wood pellets only. Burning of
any other type of fuel voids your warranty.
The burn rate, BTU content and heat output will all vary
depending on the fuel selected.
Storage
•
Wood pellets should be left in their original sealed bag
until using to prevent moisture absorption
•
Do not store any pellet fuel within the clearance
requirements or in an area that would hinder routine
cleaning and maintenance
9
E. Before Your First Fire
1. First, make sure your appliance has been properly
installed and that all safety requirements have been
met. Pay particular attention to the fire protection,
venting and thermostat installation instructions.
2. Double check that the ash drawer and firebox are
empty!
3. Check the position of the thermocouple, located
above the fire pot, and make sure that it protrudes
approximately 3/4 inch (19mm) into the fire pot.
4. Close the front door.
IMPORTANT DETAIL: The tip of the thermocouple
must be in contact with the inside end of the
thermocouple cover or missed ignitions can occur.
F. Filling the Hopper
Open the hopper lid by lifting the handle. Fill the hopper
with fuel. Close the hopper lid. The unit will not feed with
the hopper lid open and the fire will go out.
7019-802H
04/21
Advertisement
Table of Contents
