Configuring Pulse Modulation; Setting The Rf Output Frequency; Setting The Rf Output Amplitude; Setting The Pulse Period And Width - Agilent Technologies E4428C User Manual

Configuring Pulse Modulation

Using the following procedures, you will learn how to create a pulse-modulated RF carrier.

Setting the RF Output Frequency

Preset
1. Press .
Frequency 2
2. Press >

Setting the RF Output Amplitude

Amplitude 0 dBm
Press > >

Setting the Pulse Period and Width

Pulse Pulse Period
1. Press >
Pulse Pulse Width
2. Press >
The signal generator is now configured to output a 0 dBm, pulse-modulated carrier at 2 GHz with a
100-microsecond pulse period and 24-microsecond pulse width. The pulse source is set to Internal Pulse.
(Notice that Internal Pulse is the default for the

Activating Pulse Modulation

Follow these remaining steps to output the pulse-modulated signal.
Pulse Off On
1. Press to On.
RF On/Off
2. Press .
The Pulse and RF ON annunciators are now displayed. This indicates that you have enabled pulse
modulation and the signal is now being transmitted from the RF OUTPUT connector.
Chapter 6
GHz
> .
.
100 usec
> > .
24 usec
> > .
Pulse Source
softkey.)
Analog Modulation
Configuring Pulse Modulation
211