Ducati MULTISTRADA 1260S Owner's Manual page 288

Rear brake pedal
Loosen lock nut (4).
Turn pedal stroke adjusting screw (5) until pedal is in
the desired position. Tighten the lock nut (4).
Operate the pedal by hand to check that there is a free
play (C) of about 2÷5 mm (0.08÷0.19 in) before the
brake bites. If not, adjust the length of the master
cylinder pushrod as follows, using flat (D).
Loosen lock nut (6) on master cylinder rod.
Screw the rod (7) into the fork (8) to increase the free
play, or screw it out to reduce it.
Tighten lock nut (6) and check play again.
8
D
5 4
6
7
C
Fig. 235
287