Adjusting the position of the gearchange
pedal and rear brake pedal
The position of the gearchange and rear brake pedals
in relation to the footrests can be adjusted to suit the
requirements of the rider.
Adjust the pedals as follows:
Gear change pedal
Unscrew the screw (3) that retains the DQS control to
the gearchange lever.
Lock rod (1) in its flat (A) and loosen nut (2), then rotate
the uniball (4) until obtaining the desired distance
between the centres (by reducing the distance
between the centres, the gearbox pedal moves down
and vice versa).
Once the desired position is found, tighten nut (2)
against the rod while counter-holding the hexagon
socket (A).
The nominal distance between the centres (B) with
which the vehicle is delivered is: 101.5 mm (4.00 in).
286
1
A
2
4
3
Fig. 233
Fig. 234