Assembling The Unit - Stihl SR 200 Instruction Manual

Assembling the Unit

NOTICE
The solution hose and throttle cable are
already connected and must not be
kinked while assembling the machine.
The combination wrench and
screwdriver are in the supplied
accessory bag.
Fitting the pleated hose on the elbow
2
1
Open the hose clamp (1) and fit it on
N
the pleated hose (2).
Engage the tab in the recess.
N
3
Push the pleated hose (2) over the
N
slip ring (3) as far as stop.
SR 200
Line up the hose clamp (1) and slip
N
ring (3):
the two lugs (arrow) on the slip ring
–
face up.
The hose clamp's hook faces
–
outwards.
Tighten down the screw (arrow).
N
Mounting the Control Handle
2
Open up the control handle (1) with
N
liner (2) and push it over the stub (3)
of the pleated hose.
3 1
N
N
Mounting the Blower Tube and Nozzle
N
N
2
Adjusting and Securing the Control
Handle
1
3
N
5
4
Attach throttle cable to retainer (4).
Secure hose with retainer (5) to
third pleat (arrow) in pleated hose.
2 1
Push the blower tube (1) into the
stub of pleated hose (2) as far as
the stop.
Push the nozzle (3) onto blower
tube as far as stop – metering
knob (4) must be in line with the
control handle.
Put the machine on your back and
adjust the harness – see "Harness".
English
4
3
9