Adjusting The Height Of The Feed Tray; Aligning The Film Guide - Kodak X-Omat 5000 RA PROCESSOR Installation Instructions Manual

INSTALLATION INSTRUCTIONS

Adjusting the Height of the FEED TRAY

Approximately
1 mm (1/16 in.)
3 WING NUTS

Aligning the FILM GUIDE

For optimum accuracy of the Film Logging feature, align the FILM GUIDE, by doing the following steps:
[1] Check for correct operation of the 6000 FILM ACCUMULATOR BOARD, by entering diagnostics and selecting
the following. See also the Diagnostics Manual, Publication Part No. 5B6342.
GO TO SETUP and enter the Access Code
MORE
INFO
DIAG
MORE
MORE
FILM ACCUMUL
LED/DET
36
DETECTOR
CROSSOVER
ENTRANCE
ROLLERS
NIP
5 SCREWS
H108_0038ACB
H108_0038AA
3 WING NUTS
[1] Adjust the position of the FEED TRAY so that it is
approximately 1 mm (1/16 in.) lower than and
parallel to the NIP of the DETECTOR
CROSSOVER ENTRANCE ROLLERS.
[2] When the height is adjusted correctly, tighten the
5 SCREWS as shown.
Note
Do not tighten the WING NUTS.
film
FILM
GUIDE
DETECTOR
CROSSOVER
H108_0365BCB
H108_0365BA
January 1996 – 5B6339