Seq A/B/C/D; Seq Lane - Korg modvawe Owner's Manual

Motion Sequencing 2.0
Phase
°
[-180...+180 ]
This controls the start point of the shape. For example, to start in the middle of the shape, set the Phase to +180°.
Prob (Probability)
See "Step Probability" on page 35.

Seq A/B/C/D

The four Seq Lanes generate modulation sources to control other synthesis parameters, just like envelopes, LFOs, etc.

Seq Lane

Press to go to this page.
SHIFT-13...16 (SEQ A...D)
Preset, Loop (Start), to (Loop End), Mode, Repeats, NoteAdv
See "Standard Lane Controls" on page 34.
Use Shape
[Off, On]
When this is On, non-zero values will be scaled by the Shape Lane. Note that Shape interacts with Transition, below;
to hear Shapes unaltered, set Transition to Off.
Transitn (Transition)
[Off, Lin, Exp, Log, Indv]
This controls whether the pitch changes abruptly at each new step, or glides to the new value.
Off: Values will change abruptly at each step.
Lin: Values will glide linearly from step to step, as if you were moving a knob continuously. This is the default.
Exp: Values will glide from step to step, with most of the change at the end of the glide.
Log: Values will glide from step to step, with most of the change at the start of the glide.
Indv (Individual): Transitions will be controlled separately per Step. This lets you create complex patterns which
combine abrupt steps and glides.
Rec Knob
[Read-only]
If the Seq Lane was created by real-time recording, this shows the name of the parameter that was recorded. (See "Real-
time recording for Seq Lanes A-D" on page 29.) Otherwise, it shows None. Note that the Seq Lane may be modulating
other parameters as well, and that the modulation routing to the recorded knob may be changed or even deleted
entirely.
42