Randomize; Using Randomize - Korg modvawe Owner's Manual

Randomize

Randomize uses a combination of preset selection and select value randomization, rather than direct randomization of
all parameters.

Using Randomize

To randomize the entire Performance:
1. Press the (Randomize) button.
The Randomize page will appear, with Scope set to Performance by default. If Scope has been previously changed to
another setting, hold and press PERFORM.
Depending on the Scope, additional settings may appear:
Fx/Mod Knob Values randomizes the Mod Knobs (Program and/or Performance, according to Scope) and Effects
Edit 1/2/3 by the specified percentage.
Modulation Intensities randomizes the standard LFO and Envelope intensities for Filter, Amp, Osc 1/2, and Pitch.
Randomize Fx Enables controls the On/Off settings for the Effects (with probability weighted towards On).
2. Press again to randomize everything in all layers, and then
To randomize a specific section of the synth:
1. Press and hold .
2. While holding , press the button for the desired section (PERFORM,
GIATOR, FILTER TYPE, AMP, PITCH,
(pressing SHIFT is not required for Lane selection here); or move a Filter or MOD knob.
The Randomize page will appear, with the selected Scope. You can still change the Scope again, if desired. Additional
Scope options are available from the on-screen menu.
3. Press to execute the randomization, and then
Randomize
ENTER
LAYER A/B, or any Effect); press a Motion Sequence Lane button
ENTER to confirm.
89
to confirm.
WAVE SELECT, SEQ STEPS, ARPEG-