Parker A Series Installation & Service Instructions Manual page 4

isysNet 24 VDC Output Modules, Series A
Install the Digital Output Module
To Install the Digital Output Module, Proceed as Follows:
1. Using a bladed screwdriver, rotate the keyswitch on the mounting
base clockwise until the number 1 aligns with the notch in the
base.
2. Position the module vertically above the mounting base. The
module will bridge two bases.
Module Will Bridge Two Bases
3. Push the module down until it engages the latching mechanism. You
will hear a clicking sound when the module is properly engaged.
The locking mechanism will lock the module to the base.
Remove the Digital Output Module From the
Mounting Base
To Remove the Module from the Mounting Base:
1. Put a flat blade screwdriver into the slot of the orange latching
mechanism.
2. Push the screwdriver toward the I/O module to disengage the
latch. The module will lift up off the base.
3. Pull the module off of the base.
Wire the Output Modules
Following are wiring instructions for the digital output modules.
PSST8M23A
2
3
(view into connector)
Pin 1 - Output 0
Pin 2 - Output 1
Pin 3 - Output 2
Pin 4 - Output 3
Pin 5 - Output 4
Pin 6 - Output 5
1 8
9
7
10
12
6
11
4 5
Pin 7 - Output 6
Pin 8 - Output 7
Pin 9 - Return (Com)
Pin 10 - Return (Com)
Pin 11 - 24VDC
Pin 12 - Chassis
PSST8M12A
(view into connector)
Pin 1 - 24VDC
Pin 2 - Output 1 (M12-A)
Output 3 (M12-B)
Output 5 (M12-C)
Output 7 (M12-D)
Pin 3 - Common
PSST8M8A
(view into connector)
Pin 1 - 24VDC
Pin 3 - Common
Pin 4 - Output 0 (M8-A)
Output 1 (M8-B)
Output 2 (M8-C)
Output 3 (M8-D)
Output 4 (M8-E)
Output 5 (M8-F)
Output 6 (M8-G)
Output 7 (M8-H)
PSST16M12A
(view into connector)
Pin 1 - 24VDC
Pin 2 - Input 1 (M12-A)
Input 3 (M12-B)
Input 5 (M12-C)
Input 7 (M12-D)
Pin 3 - Common
Pin 4 - Input 0 (M12-A)
Input 2 (M12-B)
Input 4 (M12-C)
Input 6 (M12-D)
Pin 5 - No Connect
4
E107P
Pin 4 - Output 0 (M12-A)
Output 2 (M12-B)
Output 4 (M12-C)
Output 6 (M12-D)
Pin 5 - No Connect
Input 9 (M12-E)
Input 11 (M12-F)
Input 13 (M12-G)
Input 15 (M12-H)
Input 8 (M12-E)
Input 10 (M12-F)
Input 12 (M12-G)
Input 14 (M12-H)