Mount The I/O Base - Parker A Series Installation & Service Instructions Manual

isysNet 24 VDC Output Modules, Series A

Mount the I/O Base

To mount the I/O base on a wall or panel, use the screw holes
provided in the base.
IMPORTANT
The I/O module must be mounted on a grounded metal mounting
plate or other conductive surface.
A mounting illustration for the base with an adapter is shown below.
1.9
(47.2)
Adapter
4.02
(102)
1.81
(46)
Inches
(mm)
2.0 0.87 2.0
(50) (22) (50)
Drill and Tap
for M4 Screw
3.13
(79.4)
3.02 5.39
(76.6) (137.0)
* Depending on the type and number of manifolds, this dimension
may vary. Refer to Catalog 0600P-# for additional information.
Install the Mounting Base as Follows:
1. Lay out the required points as shown above in the drilling
dimension drawing.
2. Drill the necessary holes for #8 (M4) machine or self-tapping
screws.
3. Mount the base using #8 (M4) screws.
4. Ground the system using the ground lug connection. (The ground
lug connection is also a mounting hole.)
Mounting Base
Keyswitch-
Set to position 1
for the PSST8M
digital output
modules
3
5.98*
(151.9)
Drill and Tap
for M6 Screw
Ground Lug
Connection
Latching Mechanism
E107P
2.39
(60.7)
4.32
(109.8)