Advertisement
Updating Procedure
NOTICE
Please save your important data onto the USB storage device before updating the firmware of the
DTX900M/DTX900/DTXTREME III.
1.
After downloading, decompress the archived file, and then find the "***.PGM" file. Copy the
"***.PGM" file to the root of the USB storage device.
2.
Make sure to turn the power off (the Standby/On switch is set to the Standby position,) and then
connect the USB storage device to the [USB TO DEVICE] terminal on the rear panel.
3.
Hold down the [F1] and [REC] buttons simultaneously, and then turn the power on by pressing the
Standby/On switch.
4.
Press the [ENTER] button to start the update process. This process takes a few minutes.
5.
When the update process is completed, following message will appear, and you can turn the power
off (the Standby/On switch is set to the Standby position.)
DTX900/DTX900M: Completed. Reboot DTX900.
DTXTREME III: Completed. Reboot DTXTREME III.
6.
Confirm the version of the firmware as described in "Confirming the Current Version."
This completes the update process.
IMPORTANT
If your DTXTREME III and computer are connected using a USB cable:
After executing the update program, download the latest USB-MIDI driver from the following website:
http://download.yamaha.com
DTX900M/DTX900/DTXTREME III Firmware Update Guide
3
Advertisement
