Adjusting The Sound - BenQ MS614 User Manual

1. Press CAPTURE on the remote control.
2. A confirmation message displays. Press CAPTURE or MODE/ENTER again.
3. The message 'Screen Capturing...' displays while the projector is processing the
picture. Please wait.
4. If the action is successful, you see the message 'Captured Succeeded' on the screen. The
captured picture is saved as MyScreen.
5. To view the captured picture displayed as the startup screen, set MyScreen in the
SYSTEM SETUP: Basic > Splash Screen menu and restart the projector.
• Using the OSD menu
1. Press MENU/EXIT and then press
highlighted.
2. Press
3. Repeat steps 2-5 in the "Using the remote control" section to capture and view the
captured picture.
In the unlikely event that the capturing action fails, change your target picture.

Adjusting the sound

The sound adjustments made as below will have an effect on the projector speakers. Be sure
you have made a correct connection to the projector audio input. See
15 for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1. Press MENU/EXIT and then press
is highlighted.
2. Press
page displays.
3. Highlight Mute and press
Adjusting the sound level
To adjust the sound level, press VOLUME+/VOLUME- on the remote control, or:
1. Repeat steps 1-2 above.
2. Press
Turning off the Power On/Off Ring Tone
To turn off the ring tone:
1. Repeat steps 1-2 above.
2. Press
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
to highlight MyScreen and press MODE/ENTER.
to highlight Audio Settings and press MODE/ENTER. The Audio Settings
/
to highlight Volume and press
to highlight Power On/Off Ring Tone and press
/ until the SYSTEM SETUP: Basic menu is
/ until the SYSTEM SETUP: Advanced menu
to select On.
/ to select a desired sound level.
"Connection" on page
/ to select Off.
Operation 33