Delta AC MAX Installation And Operation Manual page 10

About the Product
Safety Instructions
Disconnect all electrical power prior to installing the product. Failure to do so may result in elec-

tric shock, physical injury or damage to the electrical system and charging unit.
The product can only be installed by licensed contractors, or licensed electricians in accordance

with all applicable state, local and national electrical codes and standards in a location with non-
restricted access.
Before installing the product, review this manual carefully and consult with licensed contractors,

licensed electricians, and installation experts to ensure compliance with local building practices,
climate conditions, safety standards, and state and local codes.
Use appropriate protection when connecting to the main power distribution cable.

Danger of electrical shock or injury. Turn OFF all power at the panel board or load center before

working inside the equipment or removing any component. Do not remove circuit protective
devices or any other component until the power is turned OFF.
The product must be connected to a grounded, metal, permanent wiring system or an equip-

ment grounding conductor must be run with the circuit conductors and connected to the equip-
ment-grounding terminal or lead on the product.
1-5
Installation Environment and Safety Instructions
Installation and Operation Manual