Sony HCD-DZ100 Operating Instructions Manual page 72

[CENTER]
3.0 m/10 ft*
(appears when
you set
[CENTER] to
[YES] in the
[SIZE] setting.)
[SURROUND]
3.0 m/10 ft*
(appears except
when you set
[SURROUND]
to [NONE] in the
[SIZE] setting.)
* When you perform the Quick Setup (page 26), the
default settings are changed.
Note
• When you set the distance, the sound cuts off for a
moment.
• If all front and surround speakers are not placed at an
equal distance from your listening position, set the
distance according to the closest speaker.
• Do not place the surround speakers farther away from
your listening position than the front speakers.
• Depending on the input stream, the [DISTANCE]
setting may not be effective.
x [LEVEL (FRONT)]
You can vary the level of front speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
[L]
0 dB
[R]
0 dB
[CENTER]
0 dB
(appears when you
set [CENTER] to
[YES] in the [SIZE]
setting.)
[SUBWOOFER]
0 dB
x [LEVEL (SURROUND)]
You can vary the level of surround speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
(This settings appear except when you set
[SURROUND] to [NONE] in the [SIZE]
setting.)
72
GB
Center speaker distance from the
listening position can be set in 0.2
meter (1 ft) increments from 0.0 to
7.0 meters (0 to 23 ft).
Surround speaker distance from the
listening position can be set in 0.2
meter (1 ft) increments from 0.0 to
7.0 meters (0 to 23 ft).
Set this between –6 dB and 0 dB
in 1 dB increments.
Set this between –6 dB and 0 dB
in 1 dB increments.
Set this between –6 dB and +6 dB
in 1 dB increments.
Set this between –6 dB and +6 dB
in 1 dB increments.
[L] Set this between –6 dB and +6 dB in
0 dB
1 dB increments.
[R] Set this between –6 dB and +6 dB in
0 dB
1 dB increments.
To adjust the volume of all the
speakers at one time
Use the VOLUME control on the system, or
press VOLUME +/– on the remote.
x [TEST TONE]
The speakers will emit a test tone to adjust
[LEVEL (FRONT)] and [LEVEL
(SURROUND)].
[OFF] The test tone is not emitted from the
speakers.
[ON] The test tone is emitted from each speaker
in sequence while adjusting level. When
you select one of the [SPEAKER SETUP]
items, the test tone is emitted from each
speaker in sequence.
Adjusting the speaker level by
using the test tone
1
Press DISPLAY when the system is
in stop mode.
The Control Menu appears.
2
Press X/x to select
then press ENTER.
The options for [SETUP] appear.
3
Press X/x to select [CUSTOM], then
press ENTER.
The Setup Display appears.
4
Press X/x repeatedly to select
[SPEAKER SETUP], then press ENTER
or c.
5
Press X/x repeatedly to select [TEST
TONE], then press ENTER or c.
6
Press X/x repeatedly to select [ON],
then press ENTER.
You will hear the test tone from each
speaker in sequence.
[SETUP],