Table of Contents
Advertisement
Firmware Configuration Tools
1
ACC USB Client Application
1.1.2 Configuring the ACC USB Client Application
6 | 38
First time that the ACC is plugged in via the USB-B port, it may take a minute or
two to configure the USB to Ethernet interface. This is normal, and the delay
should not occur again.
1. Run the ACC USB client application.
ACC USB Client Login
The
2. Enter the default user name and password to start the Telnet session for
configuring the ACC network parameters.
If you are using MP2.70 (or later) version of the ACC and the default (or
weak) password is set, you will be prompted to enter a new password
before configuring the network settings.
If you are using MP2.70 SP1 (or later) version, when you change the
SIEMENS user password, the password for the "root" user for a SSH
connection will also be changed to the same password that was set for the
SIEMENS user.
3. Set the following parameters for the ACC in
–
Ethernet IP address
–
Subnet mask
–
Gateway IP address
–
Host IP address
–
Port
4. Click Apply
dialog is displayed.
Network Settings
section:
A6V11164550
Advertisement
Table of Contents
