Table of Contents
Advertisement
Access Controllers
2
AC5102 (ACC-G2)
2.2.6 Recovering a Non-responsive Board
2.2.7 ACC-G2 Firmware Update Procedures
2.2.8 Restoring/Updating Platform via SD Card
2.2.8.1 Preparing the SD Card
16 | 38
See section Restoring/Updating Platform via SD Card [➙ 16] for details.
See section Common Firmware Update Procedure [➙ 11] for details.
Before you begin, prepare the SD Card by following the steps below:
1. Insert the SD card into the computer (512MB minimum - 2 GB maximum,
512MB recommended for compatibility with older ACC revisions).
.gz
2. Find compressed
Win32DiskImager
3. Use
~.wic
the
file to the SD Card.
Win32DiskImager
defaults to open a file of extension type
browse to the location of the SD card image file and load it, then click the Write
button.
Note: Win32DiskImager must be installed on your computer, not on the SD card.
SD_Card
image in
folder. Unzip to extract the
Tools\ACC-G2 SD-Card Creator Tool
(in
.wic
file.
folder) to write
*.img
*.*
, so select
,
A6V11164550
Advertisement
Table of Contents
