Setting Up Your Scanner; Installing And Replacing Batteries - Uniden EZI33XLT+ Owner's Manual

SETTING UP YOUR SCANNER

These guidelines will help you install and use your new
scanner:
• If your scanner receives interference or electrical noise,
move the scanner or its antenna away from the source .
• To improve the scanner's reception, use an optional
external antenna designed for multiband coverage .
(You can purchase this type of antenna at a local
electronics store) . If the optional antenna has no cable,
use 50 Ohm coaxial cable for lead-in . A mating plug
might be necessary for the optional antennas .
• Do not use the scanner in high-moisture environments
such as the kitchen or bathroom .
• Avoid placing the scanner in direct sunlight or near
heating elements or vents .

INSTALLING AND REPLACING BATTERIES

You can power your scanner using
two AA NiMH batteries .
1 . Make sure the power is turned off .
2 . If the belt clip is attached, remove it
(See page 16) .
3 . Slide the battery compartment cover
down as shown .
UNIDEN EZI33XLT+
12
Scanner