Steps
1. Locate the system board slot on your computer.
2. Align and install the HDD into the computer
3. Replace the four (M2x4) screws that secure the HDD to the computer.
4. Connect the HDD cable on to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Install the
microSD
card.
3. Install the
SIM
card.
4. Exit
Service
Mode.
5. Follow the procedure in
Battery cable
Removing the battery cable
Prerequisites
1. Follow the procedure in
2. Remove the
SIM
card.
3. Remove the
microSD
4. Remove the
base
cover.
NOTE:
If battery is disconnected from system board for service, then there is a delay during system boot as the system
undergoes RTC battery reset.
About this task
The following images indicate the location of the battery cable and provide a visual representation of the removal procedure.
36
Removing and installing components
After working inside your
Before working inside your
card.
computer.
computer.