Razor E PRIME AIR Owner's Manual page 7

ASSEMBLY AND SET-UP
Attaching the Handlebars
Required Tool: 5 mm Allen Wrench (included)
1.
Using the 5 mm Allen wrench
loosen the handlebar clamp.
4
To adjust the height of the handlebars, open the
quick-release lever and slide the T-bar to the desired
position and resecure the quick-release lever to lock
into place.
Collar Clamp
3 3
Throttle (Black Lever)
Brake (Red Lever)
2
Insert the handlebar with
controls (brake and throttle) facing
the rider.
5
The tension of the quick-release lever can be
adjusted by manually tightening or loosening the Allen
bolt. Be careful not to overtighten. You should always be
able to open and close the quick-release lever by hand
and the T-bar should slide freely when the quick-release
lever is open.
1
4
3
Using the 5 mm Allen wrench
tighten the handlebar clamp.
2
5
WARNING: Failure to
properly secure the quick-release
lever may cause the T-bar to
telescope up or down while riding
and may cause you to lose control
and fall.
WARNING: Failure to
properly tighten the collar clamp
may allow the handlebars to
dislodge while riding and may
cause you to lose control and fall.
When correctly tightened, the
handlebars will not rotate out of
alignment with the front wheel
under normal circumstances.