Murray 465307X51A Operator's Manual page 30

Maintenance
Remove and Install the Mower Housing
1. Move the blade rotation control (1) to the
DISENGAGE position (see Figure 2).
2. Move the lift lever (2) to the level adjustment
position.
WARNING
The lift lever is spring loaded. Make sure the lift
lever is locked in the LEVEL ADJUSTMENT
position.
3. Remove the hair pins and the washers from the
suspension arms (3). See illustrations "C" and "D."
4. Remove the hair pins and washers from the lift links
(4). See illustrations "A" and "B."
5. Disconnect the extension spring (5) from the blade
control rod (6). See illustration "E."
6. Disconnect the front hanger (9) from the axle support.
See illustration "F."
7. Remove the mower drive belt (7) from the stack
pulley (8).
8. Pull the mower housing away from the right side of
the unit.
9. To install the mower housing, reverse the above
steps.
Replace the Fuse
If the fuse is blown, the engine will not start.
Remove the fuse and replace with a 15 amp automotive
fuse.
Storage (over 30 days)
At the end of each year, prepare the unit for storage as
follows.
1. Drain the fuel from the carburetor and the fuel
tank. Change the engine oil. See the engine
manufacturer's instructions.
2. Clean the entire unit.
3. Charge the battery.
30
Order Replacement Parts
The replacement parts are shown either on the back
pages of this Instruction Book or in a separate Parts List
Book.
Use only manufacturer's authorized or approved replace-
ment parts. Do not use attachments or accessories not
specifically recommended for this unit. In order to obtain
proper replacement parts, you must supply the model
number of your mower (see nameplate).
Replacement parts, except for the engine, transmission,
transaxle or differential, are available from the store
where the mower was purchased or a service shop rec-
ommended by the store.
Warranty service is available only through Authorized
Service Dealers. Locate your nearest dealer in our locator
map at www.murray.com.
Replacement parts for the engine, transaxle, or transmis-
sion are available from the manufacturer's authorized
service center found in the commercial pages of the tele-
phone directory. Also, see the individual engine or trans-
mission warranties to order replacement parts.
When ordering, the following information is required:
(1) Model Number
(2) Serial Number
(3) Part Number
(4) Quantity
en