Accessing The Atp-2000 Control Screen; From Gv Orbit Client; From A Web Browser - GRASS VALLEY ATP-2000 User Manual

In this way, the ATP-2000 automatically joins the GV Orbit system and is seen by all GV Orbit
Clients and appears as a device in a GV Orbit Client's Network window.

Accessing the ATP-2000 Control Screen

From GV Orbit Client

When DHCP is enabled on the ATP-2000 panel (default) and when the network that the GV
Orbit system uses has multicast enabled, then an ATP-2000 panel can be discovered and
appear in the Network window of the GV Orbit Client. If the panel has not yet been set up,
then it appears in the 'unassigned devices' section of the Network window.
In this case, to view the control screen (web page):
1 Right-click on the ATP-2000 item in the Network window and select 'Control' .
The unit's control screen web page is shown. See Figure 3-3.
(See
Fig. 3-3: ATP-2000 Web Page

From a Web Browser

To initially display the device's control screen (web page) without a GV Orbit system:
1 Note down the IP address of the unit, shown on its splash screen at start up (see
Figure 3-1
2 Enter the IP address of the unit into a web browser (for example, Chrome).
The unit's control screen (web page) is shown. See
ATP-2000 Control Screen (Web
Note: The ATP-2000 control screen (web page) is wide. Use pan/scroll bars
to navigate the extent of the screen, if necessary.
on page 14).
Page), on page 21 for a full description.)
Figure 3-3
ATP-2000
User Guide
on page 17.
17