•
Physical Address
Physical Address - displays the physical address of the
network card used for the network.
•
MTU
MTU - specifies the largest packet size permitted for
internet transmissions:
–
Automatic
Automatic: sets the MTU (Maximum Transmission Unit
at 1500).
–
Automatic by DHCP: sets the MTU according to the
Automatic by DHCP
DHCP connection.
–
Manual: allows you to manually set the MTU.
Manual
COaX LINk
•
Privacy - to set Privacy
Privacy -
This causes all devices connected to the coaxial cable to
use the same password. This is recommended. To set the
password, enter the Coax Link password in the Password
field.
•
To enable or disable the Coax link, click Disable
•
To view the devices connected using the coaxial cable,
click the Go to WAN Coax Status
•
In the Internet Protocol
following:
–
No IPv4 Address: the connection has no IP address.
No IPv4 Address
This is useful if the connection operates under a
bridge.
verizon.com/business/products/fios-internet
Privacy, select the Enabled
Go to WAN Coax Status link.
Internet Protocol section, specify one of the
05 / USING NETWORK
Enabled check box.
Disable or Enable
|
©2020 Verizon. All Rights Reserved
CONNECTIONS
76
Password
Enable.