Long Term Event History; Rapid Resume Logic - Directed Electronics Automate AM5 Installation Manual

Long term event history

The control module stores the last 2 triggers (Zones) in
memory.
To access the event history:
1. Turn the ignition switch off and press and hold the integrated LED/
Valet switch.
2. While holding the integrated LED/Valet switch turn the ignition
On.
3. Release the integrated LED/Valet switch.
4. Within 5-seconds, press and release the integrated LED/Valet
switch.
5. The LED flashes in groups indicating the last two zones triggered.
For example, if Zone2 and 3 were the last two zones to be trig-
gered, the LED flashes two times followed by a pause and then
flashes three times followed by a pause.(See Table of Zones on p.
31 for trigger information)
The Long Term Event History will exit if the ignition is turned off or there
is no activity for 60-seconds.

Rapid resume logic

The current state of the alarm is stored in non-volatile memory. If power
is lost and then reconnected, the system recalls the stored state from
memory (arm, disam, and Valet mode).
32
© 2008 Directed Electronics All rights reserved.