Door Lock Harness (H3); Plug-In Harnesses - Directed Electronics Automate AM5 Installation Manual

➤ Door lock harness (H3)

The module can control 2 common power door lock types without
any additional parts. With certain vehicles, or if an actuator is to be
installed, either a 451M Door Lock Relay Satellite or two relays are
required. Refer to TechTips document 1041 for wiring information.

➤ Plug-in harnesses

Integrated LED/Valet switch
The integrated LED/Valet switch should be accessible from the driver's
seat. The Valet part of the integrated LED/Valet switch plugs into the
blue port on the side of the unit.
Check for rear clearance before drilling a 5/16-inch hole and mount-
ing the switch. The LED part of the integrated LED/Valet switch operates
at 2V DC and plugs into the white port on the side of the unit. Make
sure the LED wires are not shorted to ground, as this can cause dam-
age to the LED.
Programmer interface
The black 3-pin port is provided for programming the unit using the
Bitwriter® (p/n 998T). Using the Bitwriter you can configure each one
or all of the programmable functions. You can also lock the remote
control and system features learn routines so unauthorized users cannot
change the configuration or program the remote controls to the unit. If
the learn routines have been programmed using the Bitwriter, they may
be locked. Before re-programming the learn routines, first unlock them
with the Bitwriter. You cannot unlock the previously programmed learn
routines manually with the valet switch.
26
© 2008 Directed Electronics All rights reserved.