Nb08Pt-18 Troubleshooting Guide - Stanley NB08PT-18 Instruction Manual

9. NB08PT-18 TROUBLESHOOTING GUIDE

WARNING: Read instruction manual for tool itself together to understand the troubleshooting of tool.
Faulty Causes
Power does not turn
ON
Screen freezes at
Stanley Engineered
Fastening Logo
Tool do not function
when mandrel was
push
Tool does not operate
when trigger switch is
pressed.
Insuffi cient or excessive
fastening stroke.
Stroke and Force value
setting cannot change
Tool does not count
correctly (does not
count or counts even if
it does not set nut).
Assumed fully charge
battery fasterned low
number of nuts.
1. Battery is not fully attached.
2. Battery is not fully charged.
3. Battery is malfunction.
4. Trigger module malfunction.
1. Data reading error.
2. Smart screen malfunction.
3. Trigger module malfunction.
4. Setting data are broken.
1. Screen is not home screen
(Counter screen).
2. Screen malfunction, freezing or all
white.
3. Alarm message is shown with beep
sound.
4. Setting data are broken.
5. Radio communication error.
6. If tool is already operating
1. Screen is not home screen
(Counter screen).
2. Screen malfunction, freezing or all
white.
3. Not in operating
1. Inappropriate setting value of
fastening stroke or fastening load
2. Malfunction of control part.
3. Setting fi le is malfunction.
4. Trigger module or screen module
malfunction.
1. Value setting cannot be selected
2. Wrong password
1. Fastening force is too low.
2. Battery is not fully charge.
3. Battery is malfunction.
4. Setting fi les are malfunction.
5. Calibration abnormal
1. Battery is not fully charge.
2. Battery is malfunction.
Solutions
Remove battery and re-insert. Reset
tool to home.
Charge battery.
Replace battery.
Contact a local service centre.
Remove battery and reinsert. Press
trigger to turn ON.
Contact a local service centre.
Contact a local service centre.
Restore to factory setting.
Get screen to home scrren. Touch
"Back home" icon to be back home.
Remove battery and reinsert. Press
trigger to turn ON. Or set the tool to
default. If not solve, contact a local
service centre.
Reset alarm refering to the related
pages.
Restore to factory setting.
Restore to factory setting. If not slove,
contact local service centre.
Continue with fastening or enforced
spin off
Get screen to home scrren. Touch
"Back home" icon to be back home.
Remove battery and reinsert. Press
trigger to turn ON. Or set the tool to
default. If not solve, contact a local
service centre.
Get the tool to operate
Please use appropriate setting value
Set up to factory default condition. If it
does not return,contact a local service
centre.
Restore to factory setting.
Contact a local service centre.
Select the value setting method
correctly.
Default password: 2000
Reset stroke and force.
For aluminum M3 at extremely low
force, it cannot count in some cases.
Check battery charge level and charge
battery if low.
Replace battery
Restore to factory setting.
Contact a local service centre.
Check the battery level and fully
charge the battery.
If power consumtion is faster than
usual, replace battery.
35
E N G L I S H
Page
Refer tool manual
Refer tool manual
-
-
-
-
-
27
10
27
Each
27
-
26
10
27
-
15, 16, 17
-
27
-
15
15
9
26
-
-
31
26
-