Installation Of Lens Change Table; Component; Installation Of Foot Assembly - Sony SRX-R515P Installation Manual

Before installing the lens change table, check that the image adjustment of the 2D lens and 3D lens is
completed.

6-1. Component

The lens change table consists of the following parts.
. Foot assembly:
. 3D unit assembly:
. 2D unit assembly:
. Base plate assembly:
. Stopper (A) (supplied with the base plate assembly): 2 pcs
. Stopper (B) (supplied with the base plate assembly): 2 pcs
. Plate (foot):
Required tool
. L-shaped scale (metal measure)
Required grease
. Sony grease SGL-601 (7-651-000-10)
. Screwdriver
. Hexagonal wrench: Subtense: 5 mm
. Spanner:
19 mm (for flexible leveler nut)
30 mm (for leveler nut of projector)
Tightening torque
Tighten the following screws with the tightening torque described below.
. M4: 1.5 N.m or more
. M6: 5.0 N.m or more
. M8: 12.5 N.m or more

6-2. Installation of Foot Assembly

m
. There are two sets of the foot assembly consisting of the following parts respectively.
. Frame 2
. Stay (320)
. Frame 1A
. Frame EX
. Frame 1B
. Before adjusting the length of front foot of the projector for tilting it and so on, attach the frame 2 to the
front foot of the projector and temporarily secure it with the adjuster nut. (Refer to steps 2 and 3 in
"Installing the Frame 2".)
SRX-R515P
Section 6

Installation of Lens Change Table

2 pcs
1 pc
1 pc
1 pc
1 pc
6-1 (E)