Power And Data Lines From Floor - VeriFone K450 Installation Manual

S
ETUP
Installing K450
Power and Data
Lines from Floor
CAUTION
WARNING
20
K450 I
NSTALLATION
5
Lift kiosk and align slots in base to anchors. Carefully lower the kiosk onto
anchor bolts and secure with washers and nuts. Ensure nuts are properly
tightened.
1
If power and data lines come from the ceiling, skip to next section.
2
Start routing wires at the pedestal's base.
3
If the wires come up from the floor underneath the base, run the wires through
the provided 3.5" x 1.5" cutouts. Run power lines through one cutout and data
lines through the other (check labels on base).
4
If the wires run through a conduit above the floor, use the existing routing
holes on the sides of the base. Use different holes for power and data lines.
There is a divider inside the pedestal pole to separate power and data lines.
DO NOT run power and data through the same side.
Run two data lines up through the pedestal pole on the data side of the divider.
With electrical cover removed, there is exposure to electrical hazards such as
bare electrical wire and terminals. Only personnel with proper training and
experience should remove electrical cover.
G
UIDE